1. Caring plugs.
Busi often there are multiple causes of death, for example: an ignition problem, flooding and crust plugs.
Ignition problem. Spark plug ignition easily die because of problems that not maximal. Check first coil, condenser, platinum, if already use CDI try to check pulsernya. CDI pulser function as an intermediary in order to spark the fire. If the coil is rarely broken (original). Condenser, condenser if already damaged the engine might be "mbrebet-mbrebet". Platina, check the condition of platinum, the ideal distance is 0.5 mm. Distance platinum sparks distance can not maximally, if too close. Well that's all that can cause a spark was dead easy.
2. Ignition check.
There in the old post
3. Mika Speedometer
How to care for speedometer mica cracked because the temperature is affected by rubbing oil on mica and wait a few minutes, small cracks will be obscured. Like if use face cream (for the use) let the stain obscured.
4. Cleaning the carburetor.
Cleaning the carburetor need not often. If too frequent loading and barely ntar might wear carburetor components. First, clean the filters used to filter dust. Use any kind that you think could make bersihin. Gasoline, diesel fuel, kerosene, pertamax, just do not use used oil. Not recommended also use baby shampoo brand anything what. Second, clean the carburetor. The trick, slowly loose bolts on the carburetor. Do not forget to close the gas valve was yes. Use appropriate keywords in order to let the tools do not easily "dol". Remove the carburetor components and place them in a container of cleaning fluid (not liquid toilet cleaners), let's easy to use liquid fuel. Remove the carburetor bowl, float and float needle, main jet, pilot jet, and others. Beware of the small parts and seals / rubber protector, place it in a container that is easily visible, so that later when the installation is not to look confused. If it despite all the carburetor clean with a brush, then spray the holes with high pressure air compressor could use could also use a hand pump. Use amplaz fine to clean the dirt (dust mixed with all kinds of animal dung) on nozzle-nozzle, mengamplaznya Not too much, because it can lead to the change of the size of the nozzle diameter. Once clean, replace the nozzle-spuyernya. Yes if you can use a screwdriver nozzle and pengecangannya not too hard, just use two fingers on the tip of a screwdriver.
5. Gasoline in Tank Cleaning crust.
The first, in the first drain pump. Remove the bolt faucet. If already use clean water wash. Continue on drying in the sun. If deemed already dried immediately grab the tank and reinstall it as before. Disinfection process is also to be done in order to control the tank does not fly into tubs of junk wagon.
6. Vespa wash.
"Wash your own Vespa. Heritage and Vespamu As a part of yourself."
0 comments:
Post a Comment